Neck treatment with an oblique trim

Today we will process the neck of the dress with an oblique trim. The work is not complicated, the neck looks neat and tidy. Thus, you can handle the armhole of dresses, tops, sleeveless blouses.

1. Cut out a strip of fabric-oblique inlay of the required length + 2 cm for allowances 3 cm wide strictly at an angle of 45 degrees to the direction of the warp thread.
	2. Fold the slanting collar along in half and iron.
	3. Put the collar flat again. Alternate the longitudinal sections of the inline to the narrowed bend with the wrong side inwards and ironed. Fold one of the longitudinal sections flat again.
	4. To prevent the neckline from stretching from stretching, lay a stitch along the neckline or iron the adhesive strip for the non-woven form bands (see recommendations for choosing duplicate materials for various types of fabrics). Cut allowance along the neckline. Pin the turned-out cut of the neckline (to buy tailor pins at the Burda store) to the neck cut with the front side to the front side, around the end of the neck with an allowance (if the neck is open) and stitch along the fold at a distance of 7 mm.
	5. Unscrew the tie up.
	6. Bend around the seam of the seam of the seam with a tape, tuck, pin or sweep.
	7. Lay the stitch on the front side in the seam of the sewing of the inlay. Done!