Quite often, in Burda models, the most common rep ribbon bow is used as decor. For example, on blouses to emphasize a deep neckline or on dresses, on a contrast belt.
And also on products from plain fabrics. To make such a bow from a rep ribbon with your own hands is very simple.
DIY leather bracelet with a bow
On examples of models from Burda magazine, we consider two options for decor with such a bow:
- Special offer
- 1
- 2
- 3
- 4
Option 1. Bow from rep ribbon
From a rep ribbon, cut a length of 65 cm for the bow.
Cut the ends of the rep ribbon section diagonally.
Fold and stitch the tape as shown in the figures.
Round the middle of the bow with the rest of the rep ribbon, sew the ends of the ribbon from the bottom.
Sew the bow exactly at the corner of the neckline of the back.
How to make a bow with a fork
- Special offer
- 1
- 2
- 3
- 4
Option 2. Decorative belt from rep ribbon with a bow
For a bow knot, cut a 13 cm length from the rep ribbon.
Fold the remaining rep ribbon, as shown in Figure 1, lay a line at a distance of 14 cm from the fold.
Form a bow (Figure 2), sweep in the middle.
Round a piece of rep ribbon for a bow knot around the middle of the bow, sew the ends of the ribbon from the back - see Figure 3.
Pin the rep ribbon with the bow to the set-in belt so that the bow lies along the line of the middle of the front.
Stitch rep ribbon on the set-in belt as long as possible.
At the rear ends of the set-in belt, cut off the protruding ends of the rep ribbon.
How to make a needlewoman bracelet with charms
Source and illustrations: Burda 4/2019 and 5/2019
